Electricity In Automobile — Part 1 MCQs with Explanations

Spongy lead is the correct answer to “The negative plates of a lead acid battery has”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Ampere-hour rating is the correct answer to “The capacity of a battery is expressed in terms of:”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Blue is the correct answer to “For head lamp circuit fed from terminal on terminal switch we use”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Ignition coil is installed is the correct answer to “To develop high voltage for spark plug of petrol engine”. This question is standard in competitive examination syllabi for Electricity In Automobile.

3 is the correct answer to “The candle power (cp) of parking lights is-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Share information between the different ECU's is the correct answer to “The controller area network (CAN) is used to”. This question is standard in competitive examination syllabi for Electricity In Automobile.

80 is the correct answer to “The frequency of flashing light per minute in a turn indicator is about”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Electric energy is the correct answer to “It is commonly belived that a storage battery stores the . . . . . . . . but it is not true.”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Attractive is the correct answer to “In magnet opposite poles are-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Rotor is the correct answer to “In an alternator, the magnetic field is produced in the”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Battery positive(+ve) terminal and the insulated output terminal of the alternator is the correct answer to “To check for the excessive voltage drop on insulated side of the alternator's output circuit, the voltmeter is connected between the”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Hard rubber is the correct answer to “Battery box is made up of-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Blinkers ⇔ 12 V, 18W/18W is the correct answer to “Which of the following pair(s) is not properly matched”. This question is standard in competitive examination syllabi for Electricity In Automobile.

6 is the correct answer to “The number of diodes used in alternator is/are”. This question is standard in competitive examination syllabi for Electricity In Automobile.

All of these is the correct answer to “Brown colour is used to indicate-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Direction signal direction is the correct answer to “. . . . . . . . are used to indicate the direction in which the vehicle is to tum.”. This question is standard in competitive examination syllabi for Electricity In Automobile.

All are correct is the correct answer to “Battery is used in which of the phenomenon-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Stop light is the correct answer to “. . . . . . . . are at the rear of the car and becomes on when brakes are aiming.”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Heavier is the correct answer to “During battery charge, the electrolyte becomes”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Engine problem is the correct answer to “If the engine cranks too slow to start, the problem may be caused by”. This question is standard in competitive examination syllabi for Electricity In Automobile.

About $${1 \over 2}$$ charged is the correct answer to “The state of charge of battery that has a specific gravity of 1.190 at 80°F (26.7°C) means”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Black is the correct answer to “For all ground wire we use the colour-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

54.4°C is the correct answer to “While charging a battery, the temperature of the electrolyte should not exceed”. This question is standard in competitive examination syllabi for Electricity In Automobile.

All are correct is the correct answer to “The main lights are-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Reduce the number of wires between the ECU's by allowing the information sharing is the correct answer to “The purpose of serial data communication is to”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Diode is the correct answer to “A . . . . . . . . is an electrical one-way check valve that will allow current to flow in one direction only.”. This question is standard in competitive examination syllabi for Electricity In Automobile.

1000 is the correct answer to “When electrolyte is ready then its specific gravity should be-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

1 to 15 is the correct answer to “The ratio between the number of teeth on the starter motor pinion gear and the engine flywheel ring gear is about”. This question is standard in competitive examination syllabi for Electricity In Automobile.

All are correct is the correct answer to “Charging dynamo intermittently or charging less is due to”. This question is standard in competitive examination syllabi for Electricity In Automobile.

All are correct is the correct answer to “Which of the following is the component of lead acid battery”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Negative is the correct answer to “In earth return system which terminal of the battery is earthed to the body or chassis which is made of metal-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Smaller than positive terminal post is the correct answer to “The negative terminal post on a top terminal battery is”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Series is the correct answer to “When the negative pole of one battery is connected to the positive pole of the other battery, the batteries are said to be connected in-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

All are correct is the correct answer to “Which of the following has cable size $${{14} \over {0.012}}$$”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Both is the correct answer to “Before the battery is put on charge-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Changes mechanical energy into electrical energy is the correct answer to “The function of a generator is that it”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Allow engine to warm-up quickly is the correct answer to “The main purpose of a thermostat in an engine cooling system is to”. This question is standard in competitive examination syllabi for Electricity In Automobile.

All are correct is the correct answer to “Which of the following light contains 3 cp”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Both the ways is the correct answer to “In automobiles the wires are connected in which of the following way-”. This question is standard in competitive examination syllabi for Electricity In Automobile.

Both of them is the correct answer to “End shields are made of-”. This question is standard in competitive examination syllabi for Electricity In Automobile.