Skip to main content

Transmission And Distribution — Part 2 MCQs with Explanations

Practice high-yield Electrical Engineering MCQs on Transmission And Distribution — Part 2 with worked academic solutions for WAPDA, NTDC, IESCO, LESCO, PPSC, FPSC.

Questions
40
Difficulty Level
Exam-Level
Target Exams
WAPDA, NTDC, IESCO...
Estimated Time
48 mins
Exam-Level WAPDA NTDC IESCO LESCO PPSC FPSC
Verified for Commission Syllabus • Oct 14, 2026
40

Verified Practice Questions

Interactive test mode with detailed academic worked solutions

Live Progress | 0/40 answered
✓ 0 correct ✗ 0 wrong 0% score
Question 1 of 40
★ WAPDA ★ NTDC

Transmission voltage of ll kV is normally used for distances upto

Question 2 of 40
★ WAPDA ★ NTDC

The phenomenon of rise in voltage at the receiving end of the open-circuited or lightly loaded line is called the

Question 3 of 40
★ WAPDA ★ NTDC

Series capacitors on transmission lines are of little use when the load VAR requirement is

Question 4 of 40
★ WAPDA ★ NTDC

The voltage of the single phase supply to residential consumers is

Question 5 of 40
★ WAPDA ★ NTDC

The wooden poles well impregnated with creosite oil or any preservative compound have life

Question 6 of 40
★ WAPDA ★ NTDC

The use of strain type insulators is made where the conductors are

Question 7 of 40
★ WAPDA ★ NTDC

As compared to a 2-wire D.C. distributor, a 3-wire distributor with same maximum voltage to earth uses only

Question 8 of 40
★ WAPDA ★ NTDC

A circuit is disconnected by isolators when

Question 9 of 40
★ WAPDA ★ NTDC

Large industrial consumers are supplied electrical energy at

Question 10 of 40
★ WAPDA ★ NTDC

The distributors for residential areas are

Question 11 of 40
★ WAPDA ★ NTDC

The material commonly used for insulation in high voltage cables is

Question 12 of 40
★ WAPDA ★ NTDC

The material generally used for armour of high voltage cables is

Question 13 of 40
★ WAPDA ★ NTDC

Which of the following bus-bar schemes has the lowest cost?

Question 14 of 40
★ WAPDA ★ NTDC

Corona usually occurs when the electrostatic stress in air around the conductor exceeds

Question 15 of 40
★ WAPDA ★ NTDC

For aluminium, as compared to copper, all the following factors have higher values except

Question 16 of 40
★ WAPDA ★ NTDC

310 km line is considered as

Question 17 of 40
★ WAPDA ★ NTDC

Galvanized steel wire is generally used as

Question 18 of 40
★ WAPDA ★ NTDC

In the analysis of which of the following lines shunt capacitance is neglected?

Question 19 of 40
★ WAPDA ★ NTDC

The usual spans with R.C.C. poles are

Question 20 of 40
★ WAPDA ★ NTDC

The power factor of industrial loads is generally

Question 21 of 40
★ WAPDA ★ NTDC

The voltage regulation in magnetic amplifier type voltage regulator is effected by

Question 22 of 40
★ WAPDA ★ NTDC

Constant voltage transmission entails the following disadvantage

Question 23 of 40
★ WAPDA ★ NTDC

When a live conductor of public electric supply breaks down and touches the earth which of the following will happen?

Question 24 of 40
★ WAPDA ★ NTDC

For an overhead line, the surge impedance is taken as

Question 25 of 40
★ WAPDA ★ NTDC

Which of the following distribution systems is more reliable?

Question 26 of 40
★ WAPDA ★ NTDC

Most of the high voltage transmission lines in India are

Question 27 of 40
★ WAPDA ★ NTDC

There is a greater possibility of occurrence of corona during

Question 28 of 40
★ WAPDA ★ NTDC

By which of the following methods string efficiency can be improved?

Question 29 of 40
★ WAPDA ★ NTDC

The material commonly used for sheaths of underground cables is

Question 30 of 40
★ WAPDA ★ NTDC

For which of the following equipment current rating is not necessary?

Question 31 of 40
★ WAPDA ★ NTDC

The voltage drop, for constant voltage transmission is compensated by installing

Question 32 of 40
★ WAPDA ★ NTDC

The operating voltage of extra high tension cables is upto

Question 33 of 40
★ WAPDA ★ NTDC

When a conductor carries more current on the surface as compared to core, it is due to

Question 34 of 40
★ WAPDA ★ NTDC

Which of the following materials is not used for transmission and distribution of electrical power?

Question 35 of 40
★ WAPDA ★ NTDC

For transmission of power over a distance of 200 km, the transmission voltage should be

Question 36 of 40
★ WAPDA ★ NTDC

The steel used in steel cored conductors is usually

Question 37 of 40
★ WAPDA ★ NTDC

In a D.C. 3-wire distribution system, balancer fields are cross-connected in order to

Question 38 of 40
★ WAPDA ★ NTDC

Which of the following is not a constituent for making porcelain insulators?

Question 39 of 40
★ WAPDA ★ NTDC

In transmission lines the cross-arms are made of

Question 40 of 40
★ WAPDA ★ NTDC

The underground system cannot be operated above

✓ Link copied to clipboard
Continue Your Practice

A_C Fundamentals_ Circuits And Circuit Theory — Part 1

Master the next curriculum module with 40 exam-standard MCQs.

Next Practice Set →

💡 Examiner's Advisory for Electrical Engineering

In competitive commission exams (FPSC, PPSC, KPPSC, SPSC, CSS, PMS), questions are frequently phrased with distractor options designed to catch rote learners. Whenever you answer an MCQ, read the Detailed Academic Explanation and Conceptual Anchor to understand why the remaining options are incorrect.

More Modules in Electrical Engineering

View All →
📚

Study Guides

Topic summaries and syllabus breakdown

Explore Guides →
🎯

Complete Library

Search through 78,000+ verified MCQs

Browse Library →
📱

Mobile App

Offline mock tests and instant bookmarks

Get Mobile App →