Skip to main content

Network Theory And Analysis — Part 2 MCQs with Explanations

Practice high-yield Electronics & Communications Engineering MCQs on Network Theory And Analysis — Part 2 with worked academic solutions for FPSC, PPSC, PTA, PAEC, NTS.

Questions
40
Difficulty Level
Exam-Level
Target Exams
FPSC, PPSC, PTA...
Estimated Time
48 mins
Exam-Level FPSC PPSC PTA PAEC NTS
Verified for Commission Syllabus • Oct 14, 2026
40

Verified Practice Questions

Interactive test mode with detailed academic worked solutions

Live Progress | 0/40 answered
✓ 0 correct ✗ 0 wrong 0% score
Question 1 of 40
★ FPSC ★ PPSC

“Maximum power output is obtained from a network when the load resistance is equal to the output resistance of the network as seen terminals of the load”. The above statement is associated with

Question 2 of 40
★ FPSC ★ PPSC

“In any linear bilateral network, if a source of e.m.f. E in any branch produces a current I in any other branch, then same e.m.f. acting in the second branch would produce the same current / in the first branch”. The above statement is associated with

Question 3 of 40
★ FPSC ★ PPSC

“In any network containing more than one sources of e.m.f. the current in any branch is the algebraic sum of a number of individual fictitious currents (the number being equal to the number of sources of e.m.f.), each of which is due to separate action of each source of e.m.f., taken in order, when the remaining sources of e.m.f. are replaced by conductors, the resistances of which are equal to the internal resistances of the respective sources”. The above statement is associated with

Question 4 of 40
★ FPSC ★ PPSC

Which of the following is the passive element?

Question 5 of 40
★ FPSC ★ PPSC

For high efficiency of transfer of power, internal resistance of the source should be

Question 6 of 40
★ FPSC ★ PPSC

For maximum transfer of power, internal resistance of the source should be

Question 7 of 40
★ FPSC ★ PPSC

The circuit has resistors, capacitors and semiconductor diodes. The circuit will be known as

Question 8 of 40
★ FPSC ★ PPSC

A linear resistor having 0 < R < $$\infty \,$$ is a

Question 9 of 40
★ FPSC ★ PPSC

Superposition theorem can be applied only to circuits having

Question 10 of 40
★ FPSC ★ PPSC

The series element of a band stop filter is

Question 11 of 40
★ FPSC ★ PPSC

To replace a faulty 10 millihenry choke, you could use:

Question 12 of 40
★ FPSC ★ PPSC

The value of resistance as measured by a Wheatstone bridge is 10.0 kΩ using a voltage source of 10.0 V. The same resistance is measured by the same bridge using 15.0 V. The value of resistance is

Question 13 of 40
★ FPSC ★ PPSC

For the two port network shown in the figure The value of [h] parameter matrix is

Question 14 of 40
★ FPSC ★ PPSC

Two coils having equal resistance but different inductances are connected in series. The time constant of the series combination is

Question 15 of 40
★ FPSC ★ PPSC

In a tree number of branch b = 10, number of node n = 5. Number of fundamental loop is

Question 16 of 40
★ FPSC ★ PPSC

In the given circuit, the maximum power (in Watts) that can be transferred to the load R L is . . . . . . . .

Question 17 of 40
★ FPSC ★ PPSC

Find the resonant frequency in the below circuit

Question 18 of 40
★ FPSC ★ PPSC

A series RLC circuit has ω 0 = 10 5 , Q = 50, R = 400 Ω. The value of C is

Question 19 of 40
★ FPSC ★ PPSC

Determine the current i 1 in the network.

Question 20 of 40
★ FPSC ★ PPSC

A delta-connected network with its Wye-equivalent is shown in the figure. The resistances R 1 , R 2 and R 3 (in ohms) are respectively

Question 21 of 40
★ FPSC ★ PPSC

For a pair of lossless magnetically coupled coils with respective self inductances L 1 , L 2 (with L 1 < L 2 ) and mutual inductance M, the following is generally true.

Question 22 of 40
★ FPSC ★ PPSC

The input voltage V 1 and current I 1 for linear passive network is given by V 1 = AV 2 - BI 2 and I 1 = CV 2 - DI 2 Now consider the following network: Which one of the following is the transfer matrix \[\left[ {\begin{array}{*{20}{c}} {\text{A}}&{\text{B}} \\ {\text{C}}&{\text{D}} \end{array}} \right]\] of the network shown above?

Question 23 of 40
★ FPSC ★ PPSC

Consider the following properties of a particular network theorem: 1. The theorem is not concerned with type of elements. 2. The theorem is only based on the two Kirchhoff's laws. 3. The reference directions of the branch voltages and currents are arbitrary except that they have to satisfy Kirchhoff's laws. Which one of the following theorems has the above characteristics?

Question 24 of 40
★ FPSC ★ PPSC

In the given circuit, the initial current i(0) = 20 Amp. Then the current in amperes at time t is:

Question 25 of 40
★ FPSC ★ PPSC

Which of the following statements is false in case of a series circuit?

Question 26 of 40
★ FPSC ★ PPSC

In the circuit shown in the figure, i(t) is a unit step current. The steady-state value of v(t) is

Question 27 of 40
★ FPSC ★ PPSC

All poles and zeros of a driving point immittance function of an L-C network

Question 28 of 40
★ FPSC ★ PPSC

For a series RLC circuit, the power factor at the lowest half power frequency is

Question 29 of 40
★ FPSC ★ PPSC

When two coils are connected in parallel and a voltage of 200 V is applied between the terminals, the total current taken by the circuit is 25 A and power dissipated in one of the coil is 1500 W, the resistance of each coil is

Question 30 of 40
★ FPSC ★ PPSC

Find the energy expended moving a charge of 40 µC through a potential difference of 5 V:

Question 31 of 40
★ FPSC ★ PPSC

A unit step voltage 2u(t - θ) is applied in a series RC circuit with R = 2 Ω, C = 1 F. Assuming zero initial conditions, find i(t).

Question 32 of 40
★ FPSC ★ PPSC

Voltage transfer function of a simple RC integrator has

Question 33 of 40
★ FPSC ★ PPSC

The switch in the circuit in the figure is in position P for a long time and then moved to position Q at time t = 0. The value of $$\frac{{dv\left( t \right)}}{{dt}}{\text{at }}t = {0^ + }$$ is

Question 34 of 40
★ FPSC ★ PPSC

All the three inductors are perfectly coupled as shown below, the value of total inductance (in Henry) across the terminal AB is

Question 35 of 40
★ FPSC ★ PPSC

Inductance has the dimensions of

Question 36 of 40
★ FPSC ★ PPSC

In the circuit shown in figure, the current through 2 Ω resistor is

Question 37 of 40
★ FPSC ★ PPSC

For any lumped network, for any cut sets and at any instant of time the algebraic sum of all branch currents traversing the cut-set branches is always

Question 38 of 40
★ FPSC ★ PPSC

The circulating current in a parallel LC circuit at any resonant frequency is

Question 39 of 40
★ FPSC ★ PPSC

In the Thevenin equivalent circuit, V th equals

Question 40 of 40
★ FPSC ★ PPSC

The unit of electrical conductivity is

✓ Link copied to clipboard
Continue Your Practice

Analog Electronics — Part 1

Master the next curriculum module with 40 exam-standard MCQs.

Next Practice Set →

💡 Examiner's Advisory for Electronics & Communications Engineering

In competitive commission exams (FPSC, PPSC, KPPSC, SPSC, CSS, PMS), questions are frequently phrased with distractor options designed to catch rote learners. Whenever you answer an MCQ, read the Detailed Academic Explanation and Conceptual Anchor to understand why the remaining options are incorrect.

More Modules in Electronics & Communications Engineering

View All →
📚

Study Guides

Topic summaries and syllabus breakdown

Explore Guides →
🎯

Complete Library

Search through 78,000+ verified MCQs

Browse Library →
📱

Mobile App

Offline mock tests and instant bookmarks

Get Mobile App →