Coal Mining Regulation In India — Part 2 MCQs with Explanations
Practice high-yield Mining Engineering MCQs on Coal Mining Regulation In India — Part 2 with worked academic solutions for PPSC Mines, KPPSC, FPSC, BPSC.
Questions
40
Difficulty Level
Exam-Level
Target Exams
PPSC Mines, KPPSC, FPSC...
Estimated Time
48 mins
Exam-Level PPSC Mines KPPSC FPSC BPSC
Verified for Commission Syllabus • Oct 14, 2026
40
Verified Practice Questions
Interactive test mode with detailed academic worked solutions
Live Progress | 0/40 answered
✓ 0 correct
✗ 0 wrong
0% score
🎉 Set complete! All 40 questions answered.
Question 1 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Question 2 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
If death results from any injury already reported as serious under sub regulation (1) or if an injury other than the serious injury becomes serious the owner/manage hall with in . . . . . . . . hours of his being informed of the same, given notice to C. I district magistrate; CI etc
Question 3 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Where the inclination of the travelling roads exceeds . . . . . . . . degree from horizontal be provided in addition to the steps with hand rails provided
Question 4 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Where in any shaft ladders are used as a means of egress of persons employed in a mine, every ladder project atleast . . . . . . . . meters above the mouth of the shaft and above every platform, except where strong hold fasts or hand rails are provided.
Question 5 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Every man hole shall be kept of obstructions
Question 6 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
No person shall be admitted as a candidate at any examination held by the board unless he is . . . . . . . . years of age
Question 7 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
In the coal, the side shall kept sloped at an angle of safety not exceeding . . . . . . . . degree from the horizontal.
Question 8 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The width of the bench in coal or over burden in rock formation shall not be less than . . . . . . . . in mechanized opencast working.
Question 9 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
In winding engine, where the brake or brakes are power operated atleast one of them shall be arranged to be applied . . . . . . . . at all the time, if power supply fail
Question 10 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The rate of emission of inflammable gas per tone of coal produced exceeds . . . . . . . .m 3 in the third degree gassy mines
Question 11 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Along the haulage roadways at every roadway junction except in roadways where tramming is done by manual means where the spot levels may be shown at points not more than . . . . . . . . meters apart.
Question 12 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Where white metal used in capping tapered portion of the socket shall not be less than . . . . . . . . times of the diameter of the rope in case of diameter of the rope higher than . . . . . . . .
Question 13 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
A person appointed to superintend the lowering and raising a persons, tools, and materials and transmit signals at the top of shaft or incline.
Question 14 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Notice of disease under section 25 of act, the manager shall with in . . . . . . . . days of his being informed of the disease give notice there of in the form and method as may be specific by the CI for the purpose.
Question 15 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Each winding rope by passing the rope at speed not exceeding . . . . . . . . m/sec.
Question 16 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
All working shafts of all entrances to the mine shaft shall be adequately illuminated through out . . . . . . . . hours.
Question 17 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The voltage in the signal wires not more than . . . . . . . .
Question 18 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
When two tubs are in tandem, the gap between the inner most ends shall not be less than . . . . . . . . cm.
Question 19 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The attachment of the winding rope to the drum, depth indicator, cages, gates examined once in atleast every . . . . . . . . hours.
Question 20 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The space between detaching hook, measured from the centre of the hole for attaching it to the rope shackle and the detaching bell plate when the cage or other means of conveyance is at its normal position at the top of the shaft shall not less than . . . . . . . . where geared engine is used.
Question 21 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The period of three months ending on the 31 st March, 30 th June, 30 th September and 31 st December called
Question 22 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The outlets from a mine are under the sole control of . . . . . . . .
Question 23 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Every automatic contrivance and every brake shall be tested once atleast in every . . . . . . . . days, by raising each cage or other means of conveyance, inturn, to pass the last control point above the top most landing.
Question 24 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
A shot hole or blast hole or part there of remaining after being charged with explosive and blasted and which is not known to be misfired shot called . . . . . . . .
Question 25 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Who is responsible for effective implementation of safety management plan.
Question 26 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
It is the duties and responsibility of owner, intaking preventive and protective measure the owner shall arrange for regular assessment of the risk and, dealing with it the following order of priority.
Question 27 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
If every mine, where shaft is used for lowering or raising of person . . . . . . . . atleast number of winding ropes stocked ana kept in store.
Question 28 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
At the top of every inclined plane at least . . . . . . . . is provided to arrest tubs from runny out of control.
Question 29 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Every track where the haulage is effected by means of mechanical power or gravity, the safety contrivance fitted there on shall be examined carefully atleast once in every . . . . . . . . days.
Question 30 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
When a mine has been opened, the owner, agent or manager shall communicate the date of opening to
Question 31 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Suitable platform provided at intervals not exceeding . . . . . . . . m of the inclination of travelling roadway exceeds 60 degree from horizontal.
Question 32 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
When it is intended to bring into use any new winding installation for lowering or raising of persons, the manager shall not less than days before such use, give notice of such intention to the C.I. & R.I.
Question 33 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Every ladder in a shaft used for ingress of persons employed in a mine be made continuous or without perceptible overlapping or break except at platform which shall be provided at intervals of not more than . . . . . . . . meters.
Question 34 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Safety hooks, Jazz-rail to prevent runaway in . . . . . . . . direction.
Question 35 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The clear space of not less than . . . . . . . . m between the tubs and one side of the roadway.
Question 36 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
The manager shall make arrangement for all overman and other officials to meet him or the assistant manager once in every . . . . . . . . for the purpose of conferring.
Question 37 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
No person shall . . . . . . . . while on duty.
Question 38 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
. . . . . . . . provided below the first stop block at a distance greater than the length of set or train of tubs.
Question 39 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Every person shall, immediately before proceeding to work and immediately after terminating work at the end of his shaft have his name in the register maintain under subsection (4) of section 48 of the act
Question 40 of 40
★ PPSC Mines
★ KPPSC
★ PPSC Mines
★ KPPSC
Combination of likely hood of a specific unwanted event and its potentials consequences called . . . . . . . .
✓ Link copied to clipboard
Continue Your Practice
Next Practice Set → Coal Mining — Part 1
Master the next curriculum module with 40 exam-standard MCQs.
💡 Examiner's Advisory for Mining Engineering
In competitive commission exams (FPSC, PPSC, KPPSC, SPSC, CSS, PMS), questions are frequently phrased with distractor options designed to catch rote learners. Whenever you answer an MCQ, read the Detailed Academic Explanation and Conceptual Anchor to understand why the remaining options are incorrect.
More Modules in Mining Engineering
View All → Coal Mining — Part 1
40 MCQs
Practice →
Coal Mining — Part 2
40 MCQs
Practice →
Coal Mining Regulation In India — Part 1
40 MCQs
Practice →
Drilling And Blasting — Part 1
40 MCQs
Practice →
Drilling And Blasting — Part 2
40 MCQs
Practice →
Introduction To Mining Engineering — Part 1
40 MCQs
Practice →